adhesive friction
英
美
[网络] 黏著摩擦
双语例句
- The results show that samples have self-lubricity after copper deposition. The surface modification method can control inherent adhesive wear of pure Ti to an extent, which can reduce wear and friction coefficient.
结果表明：复合铜之后的试样具有一定自润滑性，这种表面改性方法使纯钛固有的黏着磨损得到了一定的控制，减小磨损，降低了摩擦因数。 - Adhesive friction and Transporting Safety
附着摩擦与运输安全性 - Using friction coefficient tester, we have investigated the humility and UV-light dependence of the adhesive force and friction coefficient on glass surface and nano-TiO 2 film coated glass surfaces in the relative humidity of 30%~ 70%.
在30%～70%的相对湿度范围，使用摩擦系数测定仪，研究了玻璃表面和玻璃基体上纳米二氧化钛光致双亲性膜的摩擦系数与紫外光和环境湿度的变化规律。 - The main contents are as following: ( 1) Discusses the adsorption force consists of adhesive force, negative pore water pressure and side friction.
本文的主要内容：（1）论述了吸附力由粘着力、负孔隙水压力、侧摩阻力组成。 - The results show that the plow effect between friction pairs and adhesive area of friction surface could be effectively reduced with incorporation of SiC particles, which decrease the mass-loss wear of composite plating layer.
结果表明：SiC颗粒的加入能有效地降低摩擦副之间的犁沟效应及摩擦表面发生粘着的面积，从而减少镀层的磨损。 - Calculation of Rolling Strain Velocity in Consideration of Adhesive Friction and Slide Friction
考虑粘着摩擦和滑动摩擦的轧制变形速度的计算 - We also find that, due to the water vapor condensation, the adhesive force and friction coefficient on sample surfaces increase first, then decrease with the relative humidity increase.
由于强的亲水性，样品表面的摩擦系数和黏附力随着湿度的增大先逐渐增大，然后急剧减小。 - As adhesive, matrix resin accounted for a larger proportion in non-metallic and semi-metallic friction material. Its performance direct impacts on the using performance of friction material.
基体树脂作为粘接剂，在非金属、半金属摩擦材料中所占的比例较大，其性能的好坏直接影响摩擦材料的使用性能。 - It's believed that the main wear mechanism is adhesive under dry friction, while abrasive with water lubrication, and the friction and wear performances of the composites are greatly improved with water lubrication.
水润滑条件下复合材料的摩擦磨损性能远优于干摩擦条件下的性能.干摩擦条件下复合材料的磨损机制主要为黏着磨损，水润滑条件下则以磨粒磨损为主。 - This paper sets up a mathematical model for calculating thermal balance of plunger-cylinder wall friction pair in axial plunger pump, analyzes the cause of producing adhesive wear on the friction pair, and puts forward a way to solve the problem.
本文提出了轴向柱塞泵柱塞&缸孔摩擦副热平衡计算的数学模型，进而分析了这对摩擦副产生粘着磨损的原因，并提出了解决办法。